How do I install the showerhead?
This step-by-step guide will walk you through the installation of your new filtered showerhead. Follow these easy instructions to enjoy cleaner water and an enhanced shower experience. Ensure you have all the necessary components, including plumber’s tape, a hose, and the connector, before beginning.
Turn Off Water Supply
Before starting the installation, ensure the water supply to your shower is completely turned off. This prevents any accidental water flow during the process.
Remove Old Showerhead
If an existing showerhead is installed, unscrew it carefully. Use your hands for removal or an adjustable wrench if it is tightly secured. Be mindful of residual water that may spill out.
Clean the Shower Arm
Once the old showerhead is removed, clean the threaded end of the shower arm. Ensure all old plumber’s tape, dirt, or debris is wiped away.
Apply Plumber’s Tape
Take the plumber’s tape included in your package and wrap it tightly around the threaded end of the shower arm to ensure a tight seal and prevent leaks.
Attach the Connector
Screw the connector onto the threaded end of the shower arm. Hand-tighten it until it feels snug, but do not over-tighten.
Attach the Hose
Connect one end of the hose to the connector you just installed. Tighten it by hand, ensuring it is secure but not excessively tightened.
Attach the Showerhead
Take the other end of the hose and connect it to the showerhead. Hand-tighten this connection until it is securely fastened.
Turn On Water Supply
Slowly turn the water on to allow pressure to build. Check all connections, including the showerhead, hose, and connector, for any signs of leaking.
Adjust Showerhead Position
Adjust the showerhead to your preferred position or angle, if applicable.
Test the Showerhead
Turn on the shower to verify that water flows correctly. Check again for any leaks and make any necessary adjustments.
- Choosing a selection results in a full page refresh.
- Opens in a new window.